Where Can I Buy A Blower Motor For My Furnace
Nationally, you can expect to pay about $550 on average for a blower motor replacement, including labor. However, if your unit is under warranty, you might get away with a labor-only charge of as little as $130. More complicated units, or units that are difficult to access, can cost as much as $2,000+ to replace.
where can i buy a blower motor for my furnace
There are several factors that go into the cost of replacing an HVAC blower motor. Not only is labor an important consideration, but so are factors like the size of the blower motor needing to be replaced, or if the blower motor needs to be replaced at all. Sometimes you simply need parts to get the unit going again.
The size of the blower motor is one of the most important elements in determining the cost of replacement. Labor is more or less the same, regardless of the type of motor you need, but the motors themselves can vary pretty widely in costs. The most common sizes for residential blower motors are 1/4 horsepower, 1/3 horsepower and 1/2 horsepower.
If your HVAC system is still under warranty, or your blower motor was replaced once already and is still under warranty, you will generally only pay for the labor to change the unit out and not the unit or part itself. The labor for this job runs between $200 and $400 on average, and that would be your entire bill.
The horsepower of your blower motor will influence the cost of the repair, but not always as much as it may seem. Depending on the brand of your motor, the accessibility of the unit and the type of blower motor needed, even pricing within horsepower ranges can be pretty wide.
You can expect the most common horsepower blower motors, 1/4 HP, 1/3 HP and 1/2 HP to start around $100 for parts, but they can run upward of $600, $850 and $1,200, respectively. Less common horsepower blower motors will cost more.
If you feel your furnace is on its last legs, it may be time to consider updating. Various factors determine whether or not you need to replace a furnace, including the age of your current system and the relative repair cost compared to replacement. The same principle applies to whether or not you should replace the blower motor itself.
If you need a furnace blower motor replacement, getting at least three quotes from local companies is recommended before making your final decision. Compare the pricing to choose the best value for your needs.
There are multiple causes for blower motor failure, but some are easy to diagnose and repair. Here are a few questions you can ask yourself if you suspect the blower motor is no longer working properly.
A homeowner should have their furnace checked if they are noticing decreased airflow. This is especially true if the airflow has become weaker than normal or there is no airflow. A clogged blower, leaky ducts and faulty motors can all be to blame for this issue. Either way, you should immediately call an HVAC technician to have your furnace checked out.
The most common cause of blower motor failure is a lack of maintenance, leading to dirt accumulation. However, blower motors can also fail simply due to old age, failed bearings, high amp draw or plain old electrical failure.
The cost to have a new blower motor installed by a furnace technician averages $500 to $700. But depending on the type of furnace you have, the range can be anywhere from $300 for a DIY installation to $2,000 or more for a high-end part with installation.
If you compare the cost of a new blower motor with the cost of a new furnace, along with all of the benefits of a new furnace like higher energy efficiency that produces lower running costs, a furnace will probably save money in the long run. A new furnace will be considerably more efficient and if you purchase an Energy Star unit, you may be entitled to incentives like rebates.
Before you decide to replace your old blower motor, the information below will provide you with issues to look for that will help you decide if your furnace has additional problems or just needs the blower motor replaced. If your furnace does have some of these issues, replacing the furnace is probably your best and most cost-effective choice.
If your furnace is still under warranty, the blower motor should be covered. Even newer furnaces can exhibit signs of failure but that is usually defect related rather than caused by age. Review your warranty information and contact the installer or manufacturer for details on repairing the furnace.
There are many things that can cause your air conditioning and furnace system to operate incorrectly. Sometimes it is a broken component that needs to be replaced. In this article, we look at some signs that your furnace blower motor is malfunctioning, and when you need to have it replaced.
The blower motor in your HVAC system blows the heated or cooled air through the vents in your home. The air that is heated by your furnace or cooled by your AC unit moves through your home until each room reaches its desired temperature.
Like other components in your HVAC system, the blower motor can wear down over time. Some of the reasons a blower motor might fail are overheating, and excessive moisture. When dust, dirt, and debris build up, it can cause the windings and bearings to burn up more quickly. Furnaces are usually installed in an out-of-the-way location, like the attic, basement, garage, or utility room. Blower motors that are clogged with debris, or that become saturated with moisture can fail due to overworking or electrical shorts.
Something to consider when replacing the blower motor in your HVAC system is how often you are paying for repairs. Most residential furnaces should last between fifteen and twenty years. Regular HVAC maintenance can extend the life of your furnace even longer. However, if you are paying to replace the blower motor every few years, and the life of your furnace is getting older, it may make more financial sense to get a replacement furnace instead of paying for increasingly frequent repairs.
If there is no air at all coming from your air vents when you turn on the heat, the blower motor may be completely broken. Getting a replacement motor blower would be the only choice at that point. There could be other reason why there is no airflow altogether, such as a bad relay, a faulty thermostat, or a fan control issue.
The blower motor is the component in a central HVAC system that consumes the most energy. If you already have a variable speed blower motor in your furnace, and the motor is not clogged with debris, the motor may be wearing down and approaching end of life. Dirty blowers need to work harder to push conditioned air through your air ducts, but this can also be a sign of a deteriorating blower motor. It is also possible that your air ducts have a major leak.
If you hear strange noises when you run your furnace, such as squealing, screeching, rattling, or clanking, call a heating contractor at your first convenience. Some issues may be repaired easily, but others may require a blower motor replacement.
Screeching or squealing noises can be indicative of bearing problems in direct drive furnaces, or belt issues in older belt drive furnaces. Now, if your heating system is making rattling or knocking sounds, that usually means a broken or damaged part. Banging sounds are more serious, and sometimes means that the blower motor must be replaced. A qualified HVAC technician needs to make a thorough inspection to confirm what the problem might be.
If you have an overheating blower motor, there will be clear signs. One would be a burning smell coming from your air vents every time you run the heat. Another sign is if the system shuts down, or if the blower stops while you are running the heat. This means the blower motor is overheating. If your system is shutting down to prevent electrical damage, or if the blower is shutting down, call a licensed HVAC contractor as soon as possible.
Your local licensed HVAC contractor can help you find and install the correct blower motor for your HVAC system. The heating contractor must get some information about your furnace and take a few things into account, including the type of drive, the diameter of the motor, rotation direction, horsepower, voltage, speeds, and size of the capacitor. Based on these details, the HVAC company can make the right recommendation, give you an estimate, and schedule an installation.
Ventwerx HVAC can help homeowners with a replacement blower motor for your furnace, or any other residential heating repair. We serve the San Jose area, as well as Morgan Hill and Gilroy. We are licensed and bonded, and have served the South Bay and Central Coast since 2007.
Motor strength is measured in horsepower. Most residential furnaces only need a motor of between one-fourth and one-half horsepower, but larger homes may need up to 1 horsepower. In general, the more powerful the motor, the more it costs.
Since many HVAC technicians charge an hourly rate, if your furnace or its blower motor is difficult to access, the job will take longer and thus cost more. Even if just one motor part needs replacement, the total cost will still be dependent on how long it takes to disassemble the motor to replace said part. If the furnace is located in a difficult-to-access place, like a narrow crawl space, there may be an extra fee.
Is it acceptable to replace a certain power blower motor with a lower power universal motor? For example, replacing a 1/2 HP with a universal 1/4, 1/6, 1/8 HP? I understand a 1/2 HP can be replaced with a 1/2, 1/3, 1/4 by using the right wires to match the power, but what about the prior scenario? What would happen?
The typical cost of a furnace blower motor is $450, but the final price depends on labor fees, as well as the cost of the parts. Some higher-end models feature large or hard-to-reach motors, which could bring your HVAC blower replacement cost to as much as $2,000. An active warranty means you might only pay around $150 to cover labor. 041b061a72